Firmware release notes Qolsys 2.8.0.

New Features:
• New Setting for PowerG Outdoor Siren (Activation/Comfort LED) allowing the siren’s LED to stay on
continuously.
• Added a new setting for Force Arming – if a sensor is open during arming, and Force Arm is enabled, if/when
the sensor is restored, after arming is completed, it will become armed along with the rest of the system.

Fixes/Improvements:
• Improved SRF and PowerG daughtercard discovery after panel reboot or software upgrade.
• Enabled sending and receiving of newer Z-Wave commands supported by Kwikset 620 door lock.
• Corrected an issue that could cause PowerG PIR Cams images to be sent along with the incorrect event if
activated during exit delay.
• Enhancements to the Solar UI.
• Corrected behavior for Group 43 & 44 when utilizing EN Grade 2.
• Corrected an issue that could cause IQ Remotes to not pair properly after updating panel from 2.7.1 to 2.7.2.
• Made improvements to ensure that IQ2 panels properly connect to IQ WIFI6.
• Corrected an issue where the Panel may revert to U.S. Eastern Time Zone (-5 GMT) without an active Alarm.com account, regardless of local time set on the Panel.