Firmware release notes Qolsys 4.3.0

New Features:

• Added support for the all NEW IQ Remote PowerG – (IQR-PG) •Added a new Silent Arming icon on the Panel UI
• Added a new setting for Force Arming – if a sensor is open during arming, and Force Arm is enabled, if/when the sensor is restored, after arming is completed, it will become armed along with the rest of the system
• Added remote video clip support for the IQ Panel 4 built-in panel camera – create recording rules to trigger, capture clips and upload them to the Alarm.com backend
• Added virtual device support for Wi-Fi lighting solutions such as Lutron, Deako, Jasco Pro, iDevices and Orro One Smart switches, outlets and dimmers – enabling the ability for Alarm.com supported Wi-Fi lights to be viewed and controlled from the panel
• Added virtual device support for the Alarm.com Flex IO™– Flex IO sensors are now displayed alongside other local contact sensors on the panel screen – including audible chime support for Open, Closed, and Tampered status
• Added Z-Wave multi-channel support for Alarm.com Link for Carrier – Allows the panel to connect to the Alarm.com Link for Carrier HVAC systems
• Added new options for the PowerG Siren to operate as Siren only, Strobe only or Siren and Strobe
• Added a Power Off indicator option, the Panel LED’s will flash orange in the event of a Power Failure
• Added ability to easily delete multiple images at the same time on the Panel camera UI
• Added Key switch option, when utilizing sensor type keyfob on these devices: IQ Hardwire PowerG Converter or PowerG sensors that support auxiliary inputs
• Added support for the Alarm.com S40 temperature sensor (ADC-S40-T)

Fixes/Improvements:

• Added support to display humidity on the Thermostat page
• Sensor low batteries are now displayed on the active tab
• Enlarged font on Photo Frame when displaying weather clock or time / date
• Reduced Panel boot time by 80%
• Added Partition support for Control4
• Enhancements to the Solar UI
• Panel can now display end of life (General Trouble/Fault) for PowerG CO sensors
• Added advanced settings for PowerG Shock sensor
• Added advanced settings for PowerG PIR Cameras
• Ability to disable trouble beeps sounding on PowerG Sirens
• Corrected an issue where Alarm.com cameras streaming to the Panel would not time out
• Enhanced KP-141 and KP-241 support, including full partition support
• Swinger shutdown for PowerG PIR Cameras now follow an 8-hour reset time in addition to disarming
• Enhanced PowerG PIR Cam functionality related to capturing / sending images during life safety events for PowerG 868 MHz panels (Europe)
• Corrected an issue that could cause PowerG PIR Cams images to be sent along with the incorrect event if activated during exit delay
• Corrected behavior for Group 43 & 44 when utilizing EN Grade 2
• Added additional siren timeout options for international markets
• System Check now takes a daily picture from the Panel Camera as part of its 24 hour system test. This picture is stored locally on the panel
• Includes PG Modem V4.0 firmware